0.22 Discussion thread | Use Safe Mode before reporting

Beams seem to spawn with higher spring values if hard reset. For example, ride height on vehicles might vary, and if a part with beamspring value near the point of instability is hard reset, it may become unstable but be fine after a soft reset.

 

I am the same.

 

The steering wheel nodes need to be fixed to prevent the steering wheel from ending up in the passenger seat in high speed crashes.

 

Um... all vehicles or just one?

 

All vehicles.

Maybe mount it to the end of the steering column then? So it stays as one with the steering column mesh.

 

Hey im not sure if this belongs here because its to do with both automation and beamng but if you name a car lets say van (the h series co name) if you name it that then export it to beamng the h series dissapeares and when you click on the automation one the h series stuff shows up and from there idk what hapenes since i dont wana screw up my game.
Im not sure if this happenes with other vehicles but my guess is yes.
Again not sure if this belongs here but it needs fixing

 

The only way to fix it is for you to rename your Automation export to 'van2' or something else, as your export is overwriting the existing 'van' folder in \BeamNG.drive\content\vehicles\

 

I actualy never thought of that ._.
Thanks

 

Just don`t put the steering wheel nodes into the dashboard group. just let the nodes be the steering wheel ref.nodes.

 

This curb (and the same with the other side) has been here in ECUSA for a while now, it's very brutal and doesn't line up with the ground. If you try to cut it, even with a taller car it would blow some tires or break the suspension. Cars at a normal height get caught on it.

 

The LeGran SE V6 is not using the thin whitewall tire like the SE on top of it.

 

I'm unable to start a bus route with a modded DT40L, even a skin breaks it.
I simply spawn in as a white bus (no ui or anything) and am spammed with messages like these in the console.

 

Since 0.22.2 I haven’t been able to do ANY bus route, regardless of if the bus is modded or vanilla. No matter what, all that happens is that the bus spawns but doesn’t move when I accelerate (only revs standing still with gear showing as Drive), and the scenario countdown never starts. Resetting the bus doesn’t help. Also the parts and all other menus are still accessible, which I don’t think they normally are in scenarios.

 

Stupid question: how do I restore a vanilla Beam config? I overwrote one of the vanilla LeGran configs by accident.

 

go into the vehicles folder, find the legran folder and delete the .pc file of your config name

 

That worked, thanks.