Help with adding transmission to T-Series?

I'm trying to make a transmission mod for the T-Series and am currently stuck. I tried copying and modifying lines from the file "semi_engine.jbeam" then putting that file into a folder titled "semi" under Documents/BeamNG.Drive/vehicles. After that i tried to test it out only yielding the T Series i selecting not spawning in and the console giving me about 40 lines of red text which i have taken a screenshot of but cannot remember where in the steam files they are. Any help is greatly appreciated!

 

Can you upload your .jbeam file?

 

Yes i can!

 

I haven't tested it yet, but try this:

 

The truck loaded but theres no new transmission

Edit: I stand corrected. i had to copy your jbeam file and put it in the semi folder in My Documents, its working just fine now, thanks a ton! I tried copying all the beam and node lines from the official jbeam file before starting this thread but that didn't work either. i guess i was missing the triangles section

 

You need to put it in your mods folder, otherwise you could have problems later on

 

Ok, thanks for the heads up and for the help again

 

No problem