Only one that I'd recommend is the Farming Pack low loader and/or the Fliegl ASS 298, but you can try using the other American trailers, just know the truck isn't made for them, and if it doesn't fit, it's not the trucks fault
1- It's an European truck, there could be width and/or height differences 2- Someone said the lifted suspension variants did not fit under the trailers, so this is why I mentioned it Also I never outright said there was a problem xP
Ye some of the american trailers are to low to back under but i just use node grabber to hang them a bit higher to get under. The other 8x8s people have made have the same problems but atleast the MAN rear bar doesnt foul on trailer landing gear when turning. Other 8x8s do unfortunately
I've found at least 16-speed vehicles trying to twitch every time then clutch was released after shut down.
The spinning gearbox gripping the stopped flywheel via the clutch will of course jerk the entire vehicle, this will happen with all manual and sequential transmission vehicles
How long that effect lasts? I can release the clutch many times after engine off. Every time it affects, especially at 16-sp. I think just first attemption must stops gearbox's gears completely.
Hey Alex, will you make a forklift or a new front loader to accompany the drop down sides for the cargo box on the Man? Or do you just recommend the front loader from the farming pack?
Drop down sides of cargo box? You mean dumper? That's to be mainly used with the crane and the loads the truck comes with
Yeah but there some of the 8x8 versions don’t have the crane and it would be nice to load it from the side with a forklift or a front loader because there’s only one loader and that’s the one from the farming pack
And those (along with the 3 axle variants) are meant to be just used as, well, as dumpers, and not flatbeds No special forklift or other type of loader will be made (except for maaaaybe a trailer attached forklift if an insulated trailer is made)
I was thinking about making a forklift. It could work but it might have some issues with carrying pallets due to how beamng collisions work. (Im still waiting for beam-beam collisions to be implemented)
Hello, many thanks for MAN! Could you tell me how to unhook a load from a crane? L button does not work (I can only hook) UPD: Sorry, did not notice the solution from above.
https://www.beamng.com/threads/dsc-forklift-revived.64377/ its not really immersive but thats more on the boxes than the forklift, i had to node grab it to get it on the forks.
- Spawn a crate - Press J to pause simulation - Open world editor, forgot what button it is. - Move it around using tools in button bar, not to hard to understand - To create more crates select the crate and press CTRL-C and after that CTRL-V - Leave editor press escape - Continue simulation with J This will be much faster and easier