Working on a single clutch gearbox (automated manual,semi-automatic,auto-sequential or whatever) Adjustable idle creep, adjustable launch RPM and adjustable coast/rev-match throttle custom logic ↓short video demonstration(watch the tachometer)↓
Correct, I had already made it a public release but it was far too outdated to re-relase. Mesh and jbeams are too different so I started from scratch
I Started working on my lidar based map again, I wasn't happy with the previous version of the heightmap because I had to cut a lot of detail out of it to export it as a mesh but with my new workflow I can just export the rasters straight out of cloud compare without losing any quality. This heightmap is 19997px x 15998px I'll have to crop it later and has every bit of detail that the point cloud does, I also properly separated each channel in the point cloud now so I can just setup vegetation and rocks in blender and export it into beamng without having to hand paint it.
I promised to make custom interior for my prison bus so I'm working on it. The seats can fall off the floor on high enough impact and they will bounce around inside the bus. Maybe in the future I'll also put crash test dummies on some of them.