i am currently working on a mod for the MD series and have a problem where i need to move a part and all other parts attached to it. i need to move the rear frame section forwards and I don't want to have to do it the hard way by changing every node individually
I'm not sure if there is an easy way for this specific vehicle. Usually nodeMove helps but it's already used for the suspension on the frame level. Why not move the front frame back instead so the contact point stays the same, like on every vanilla frame?
if it helps what i am doing is taken the frame and parts from the t series and adding it to the md series to make a 6x6 md series and i just want to remove the gap in the frame
You can just put the T-Series suspension on MD-Series frame, no need to copy the whole frame, they are compatible.
So if its just the jbeam that is offset you can put the jbeam into blender and move it forward and export it.
That is totally possible without needing a new front frame. Or even a new rear one. Just copypasted suspension from T-Series with different offset.
