first car i have ever attempted to make in a 3d designing program. i'm up for any suggestions you guys have to the car or my modeling (it's not very good) anyways i should hopefully finish this eventually but until the release, sit tight current progress
If it wasn't already known, this car is a rebadged version of the Chevrolet Cobalt that was sold in the US. Though the also sold the Pontiac version oddly enough. I like both cars. Where you planning on doing the turbo model?
Yeah, here it was the G5, and, very annoyingly, not available with the 2.4L engine. Of course, you could easily make a Canadian-spec version by swapping in the 2.4L from a Cobalt SS N/A, but at that point you might as well just use a 2.0 turbo instead.
Lost all my work, i'm going to retire the project, i might try again, i just need more experience. sorry everyone
You sir has gotten the award for fastest project cancelling. (Being ironic here. Too bad to see you abandoing the project)
yeah, I just need help. this is my first project, so i have absolutely no experience in this field. Maybe in a couple months i'll come back and see if i can finish it.
eh I am working on a older Pessima Wagon and an extended Roamer... I am just waiting for the correct tools because the BNEditor cannot perform what I need it to do...