With the new update for BeamNG drive out id like to suggest the creation of the automation division of the rally group. However with that in mind i would also like to suggest to set a block of restrictions and or guidelines that the rally group can follow when making these vehicles along with fine tuning and balancing like suspension, power-plants, body types etc.... I have a few picture below as an example once there setup you would not just have to rely on one person to do the fine tuning --------------------------------------------------------------------------------------------------------------------------------------------- OK due to my lack of rendering power i will just type the baseline restrictions for automation. (NOTE! This is only a baseline suggestion and my words are not what say goes that belongs to the Owner and or moderators as they have the final say.) Engine/Drive-train restrictions: Race type: Rally Engine size must not exceed 2000cc or 2 Liters Engines Can be made out of Cast-iron and aluminum however, the bottom end MUST use cast iron parts only (NA/TC/SC) NO EXCEPTIONS (unless event states otherwise) Cannot use RWD or FWD unless in a 4x4 setup AWD Is strongly recommended Race Type: Off-road/Rock-crawling/off-road time trails Engine size must not exceed 5000cc or 5 Liters Cannot use RWD or FWD unless in a 4x4 setup AWD Is strongly recommended Can only use 5 gears MAX Race Type: Drift/Circuit/On road Time-Trial Engine size must not exceed 3300cc or 3.3 Liters Race Type: Drag Engine size cannot Exceed 7000cc or 7 Liters Body restrictions: Race type: Rally can only use the following bodies: Sedan hatchback coupe Convertible Suspention/tire restrictions: Race type: Rally Suspension height cannot exceed 7.5 inches Tire size cannot exceed 23Inches in diameter despite rim size Race type: Drift/Circuit/On road Time-Trial Suspension height cannot exceed 6.5 inches Tire size cannot exceed 21 inches in diameter despite rim size Thats all of the restriction that i can think of atm anyway have fun building your cars
I would say around 2.5L however i will also suggest to make all of the bottom end cast iron on both NA and Turbo engines And restrict the drive train to AWD to make things fair. I will probably make a video on this.
