Separate names with a comma.
And yet my specs are like yours excluding the Gpu being a 950 for me
what graphics settings although gpu doesn't seem like the issue being that it is maintaining a low temp, although my GTX 950 runs a higher temp...
Haven't I drifted a "stock" t series aka no mods Hmmm lemme check my channel :p [MEDIA] I think it used stock parts Try drifting a custom fwd old...
well it seems as though the open (yolo's car) was going to maintain the right side of the road in this blind corner. Mercedes the opposite much so...
What I did in the past with particles was change how "diesel" smoke worked I made it last longer and not go up after being emitted
Perhaps when you roll over or start to pitch up or down too nuch
I will do a Civetta Bolide custom around Nurburg running a custom 3.3 with a supercharger, engine+super = 350hp and 309ft-lb of torque lets goooo...
But I'll go longer
I should retry and see how long I can go for
From my pack if and only if it still contains the engine The mod is on the repo the diesel one
Oof, I'm away from my PC, but run lockable diffs and decrease resr tire pressure to I think 30s to 40s psi Again, I don't exactly have a config...
Only modded part would be engine and maybe trans, but everything else is stock Anything else that is adjusted would be tuning
If it has alternate engine sounds then it should be my engine in my pack, I don't have a config specifically for that though
Your wheel record Vs [MEDIA]
eyyy you posted my thing perhaps I should add more :p and get a bit better at texturing too lmao OT: some exhausts I have made do actually change...
If anyone is printing with PLA, do you use anything on the printing bed to help adhesion? OT: a warped print of a ram stick, maybe in a few hours...
mods?
My soon to be default is the Civetta Bolide 3.3L. It is based on the GTR Group 4 Bolide The main change is where the 3.3L is located [ATTACH] In...
I have put laptop drives into my current pc, I even have booted from them, I put them in to do some cleaning that the original laptop would just...
@Michaelflat it isn't new [ATTACH] If I read the itty bitty picture correctly on mobile --- Post updated --- I didn't read it correctly but I'm...
