Hi everyone, I downloaded Automation a few months ago and since I discovered how to cut parts out and do stuff properly, I've been working on my family's childhood car, a 1996 VS Commodore. It's stock standard at this point. It's based on the VN shell in Automation so its back end is a little bit too square. There wasn't much I could do about that despite my best efforts. Also the interior looks like it was built out of Lego because it's just a bunch of little boxes stuck together. It's my first project in Automation so don't be too harsh. Still working on it, many bits are missing. But I'll post photos here to show how it's going so far. Incidentally, I am less than useless when it comes to building engines, so it does have a V6, but the gear ratios are all whack and stuff so it sounds bad. Any advice on that is welcome. Thanks!
Honestly, that's gotta be one of the best looking Automation models I've seen on here. Looks very true to the original car, obviously there's only so much that can be done with the interior, but it's still pretty darn good!
I very much appreciate this, thanks. Once it has working steering and gauges, I'll upload it to the repository.
