So I used Automation to make the body of a car cause it was easier and faster than doing the entire thing in Blender, however, I'll be adding doors, hood, and interior as well as other gizmos like body kits, more spoilers, headlight configurations, etcetera. Right now I need to get the base part working properly. In previous versions of automation, the exports were flawless, but now when I export a car, the exhaust is about as floppy as a flaccid dingdong. It's all over the place and flails around like a half-dead inchworm on cocaine. I've tried setting the beam spring and damp for the exhaust nodes to 0, but that completely screws up the vehicle. How do I make the floppy bits stiff? Here's what I'm talking about:
