Logitech G29 Only Works in Scenarios, not Free Roam

Hi all,

Like the title says my Logitech G29 is only working in scenarios, and not in freeroam.

It will work about 50% of the time upon entering freeroam, but switching vehicles/changing vehicle configuration will almost always cause it to stop functioning. I've managed to get it to work after switching cars around 3 times with probably 50 attempts. Restarting the game does nothing to fix the issue.

When this happens, the wheel is still being detected by the game and all the inputs are working according to the hardware settings menu, it just doesn't do anything in-game.

I've tried different drivers, different software, and completely re-installing the game, wheel software, and drivers. I don't have the issue in any other game.

I'm lost on what to do, any advice would be appreciated. I just got the wheel today and was most excited to mess around in freeroam.

 

have you got the logitech g-hub? i found my g29 worked way better with this software than without

 

Update:

Disabled all mods, re-installed ghub and un-installed LGS, problem still persists. Tested a few more of the scenarios and they also seem to have a 50/50 shot of the wheel working after loading in. So they're not consistent either.

When the wheel is doing nothing, pulling the paddles will still cause the pop-up "Gearbox currently set to arcade mode...". And, as previously mentioned, the hardware settings menu still shows that the wheel is recognized and inputs are making it to the game, the game just isn't translating those inputs into control of the vehicle I'm driving. The force feedback also completely dies when this happens, I can spin the wheel all 900 degrees with the tip of my finger with no resistance. And again, the problem is only in BeamNG, all other games work fine.

Again, so far I have:
-Disabled all mods
-Re-installed the game
-Tried LGS and Ghub, both the same result
-Completely uninstalling and re-installing the drivers

Very lost here.