1. Trouble with the game?
    Try the troubleshooter!

    Dismiss Notice
  2. Issues with the game?
    Check the Known Issues list before reporting!

    Dismiss Notice

0.18 Discussion thread | Use Safe Mode before reporting

Discussion in 'General Discussion' started by Nadeox1, Dec 9, 2019.

Thread Status:
Not open for further replies.
  1. Nadeox1

    Nadeox1
    Expand Collapse
    Spinning Cube
    BeamNG Team

    Joined:
    Aug 5, 2012
    Messages:
    14,683
    That's not bloom, but the flares.
    This is mentioned in the first post already.
    We haven't got around tuning them yet.

    With the new optimization it should matter more, as the game now uses more cores to load stuff. While before there would not be much difference as the bottleneck was elsewhere.
    The one we tested were done on an average Crucial SSD (MX100).

    There are other similar configuration to that, so that old one was removed.
    You can still recreate it on your own, as the parts are available.

    There were changes on the entire level, so is possible that some slight changes were made to that road.
     
  2. Brother_Dave

    Brother_Dave
    Expand Collapse

    Joined:
    Aug 16, 2012
    Messages:
    1,662
    Im getting that orange heaven too, or rather low gammad?

    Ive tried it on two computers since i have a history of modding lighting myself and it might leave some residue when i update. So...

    I get it on the clean install but only if i untick then tick the PostFx enable/disable box and meanwhile it looks dark and overcolorful i cant see a result of changin any/most PostFx settings. Meanhile it is this way i can change gamma and if i set it to about 1.5 it looks similar to the latest screenshots, it think.
    BUT if i click the Debug box in PostFx - HDR (so the image gets grey) while its dark and then unclick it again my game looks as i guess its supposed too, also the PostFx window works again. Managed to replicate twice ingame by unticking then ticking the PostFx enalbe box and then the same with the Debug box.

    I had similar problems a while ago when i was modding/playing around with the gamma files and Postfxmanager.gui or one of those files. Did remember that it used to give a result if i unticked and ticked the PostFx enable box, guess it reloads something.
     
    #122 Brother_Dave, Dec 10, 2019
    Last edited: Dec 10, 2019
  3. thecringes11

    thecringes11
    Expand Collapse

    Joined:
    Aug 30, 2019
    Messages:
    3
    Utah:
    The sunken bus stop near the tourist building:

    The 2 bus stop at green peak have a different signage:

    And the bus route spawn outside the repair station:
     
  4. Nadeox1

    Nadeox1
    Expand Collapse
    Spinning Cube
    BeamNG Team

    Joined:
    Aug 5, 2012
    Messages:
    14,683
    The road is simply too small. Below a certain width, the AI stops keeping the side.
    We could make it a one-way road or so.
     
  5. DD-Indeed

    DD-Indeed
    Expand Collapse

    Joined:
    Jun 22, 2016
    Messages:
    392



    Now this is interesting: I have two drives, both SSD's. The main one (C) is 250 Gb Samsung Evo 850, where I have OS and most of the programs. However, I have second drive (D), 1 Tb Samsung QVO 860, where I have all my games installed. Beam was installed on that D-drive, while mods and user settings were in the default location in C-drive. I uninstalled the game from D-drive, and manually deleted the whole game folder from there and reinstalled it on the Steam's default folder in C-drive. Results were stunning: 150 sec --> 35 sec. And all I did was to load up freeeroam in West Coast, Chinatown as the spawn spot.


    So, seems that the game doesn't like to be on that second drive at all, and makes all kinds of trouble because of that. I doubt that the drive is to blame, since I have lots of other, massive games over there that doesn't suffer from this or have any sort of issues.
     
  6. TDK

    TDK
    Expand Collapse
    FLIT KILLS MOTHS
    BeamNG Team

    Joined:
    Dec 17, 2017
    Messages:
    592
    @Speedster202
    I'm not able to reproduce (3) with the extended D's I've tested - can you confirm what you mean by 'Regular' please, and also make sure you have no mods installed.
    --- Post updated ---
    @AnOrangeHellcat
    Thank you, confirmed. The vehicle guys will fix the sound emitter location for the interior sounds.
     
    • Like Like x 1
  7. Glitchy

    Glitchy
    Expand Collapse

    Joined:
    May 26, 2015
    Messages:
    832
    Will do. It’ll be a couple hours because I’m not home.
     
  8. _Diamond_Coal_

    _Diamond_Coal_
    Expand Collapse

    Joined:
    Apr 5, 2019
    Messages:
    534
    I think taillights on newer ETKs are too orange(noticed in 0.17).
     
  9. SuperAusten64

    SuperAusten64
    Expand Collapse

    Joined:
    Jul 5, 2019
    Messages:
    864
    Headlights are now strangely inconsistent. I don't have a screenshot, but the Burnside's headlights are so dim you can barely see them (was this an intentional change?)
    Additionally, a large number of cars' lights don't get brighter when the high beams are turned on, which means the high beam switch basically does nothing.

    I might try and make a small mod out of this later, but for now, here's some old pickup configs for those who were complaining (mostly Shotgun Chuck, because even though I disagree with your views on pretty much everything, I like being able to provide things to people). You can make the D25/D35 short bed configs yourself. I have not tested these in 0.18 yet, but I know at least a couple will need to be renamed to avoid conflicting.
     

    Attached Files:

  10. 95Crash

    95Crash
    Expand Collapse

    Joined:
    Jul 29, 2018
    Messages:
    1,893
    Well, I'd figured I'd go ahead and report a curve sign issue. I have reported this issue before, but I figured I would report this issue in a better way. If you don't know what this issue is, it's a right curve on a curve that is going left.

    screenshot_2019-12-10_01-11-03.png

    This curve sign is on a road that goes off route 2 of East Coast USA. It is not that far from the town gas station. This curve sign issue road also goes a under a bridge just past the curve sign (at least in the direction this shot goes in). By the way, there is a road with a bridge the curve sign issue road goes under that you can take off Route 2 of East Coast USA into a town.

    By the way, I have another issue to report. This is a traffic light issue in West Coast USA at night. It is not that far from the gas station intersection in West Coast USA.

    screenshot_2019-12-10_01-03-50.png
     
  11. JowoHD

    JowoHD
    Expand Collapse

    Joined:
    Oct 27, 2016
    Messages:
    1,107
    thanks :p
     
  12. galaxynote2

    galaxynote2
    Expand Collapse

    Joined:
    Aug 18, 2013
    Messages:
    133
    D Series bugs:
    1) Radiator support can't be completly deattached from the body.
    2) The D25 Lifted variant uses a 5.5l V8, which in my case uses the old engine sound from v0.10
    3) After a few jumps at low speed, the 4-Link Live Axle front suspension deforms to a point that I can't drive straight anymore.
    4) It's really hard to separate the cab from the chassis if we compare how easy it is with the Bluebuck or the Burnside Special.
    5) The short frame/unibody lacks a camper shell.
     
  13. JowoHD

    JowoHD
    Expand Collapse

    Joined:
    Oct 27, 2016
    Messages:
    1,107
    this could just be a feature and not a bug but since when was the gauge cluster on the sbr4 always on? it seems weird that it's the only car (that i can think of off the top of my head) that doesn't change the lighting when the lights are turned on
     
  14. Wreck

    Wreck
    Expand Collapse

    Joined:
    Jan 3, 2017
    Messages:
    71
    Starting with version 17 of the game, the “Chase Mode” does not work fully. The car chases me very slowly and when it approaches me it slows down. No method has helped, reinstalling the game, deleting the cache, starting the game in safe mode (with default mods), reinstalling windows. How can this be? I can not fully play the game
     
  15. BlondeOfHazzard

    BlondeOfHazzard
    Expand Collapse

    Joined:
    Nov 29, 2014
    Messages:
    71
    New update plays well on the whole, I am not entirely sure about the gear whine implementation however - most manual cars have a slight whine in lower gears (loudest in 1st, gets quieter after that) which isn't replicated here (this seems to be more of an output shaft speed related noise). It would be extra good if there was some accounting for gear position as well as speed for gear whine.

    (I'm also not sure about the thumbnail lighting issues, but I see that has been reported and replied to already)
     
  16. Alex [ITA]

    Alex [ITA]
    Expand Collapse

    Joined:
    Apr 1, 2016
    Messages:
    465
    With every update you amaze me. The new lighting is just Amazing even if the thumbnail are not that good (but it has already been reported). As I reported for the Bluebuck back when 0.17 was released, it seems that the stuff in the engine bay for the D-Series and Roamer disappears after a collision.
    bug1.png bug2.png
    This doesn't seem to affect the H-Series.
    If I'll find more bugs you can be sure I'll post them.
     
  17. TDK

    TDK
    Expand Collapse
    FLIT KILLS MOTHS
    BeamNG Team

    Joined:
    Dec 17, 2017
    Messages:
    592
    It's there, but the vehicle designers haven't spent any time tweaking this yet so still very much default values stuck in at the moment. I know @Diamondback will be pleased you hear you pick up on this.
     
    • Like Like x 3
  18. BlondeOfHazzard

    BlondeOfHazzard
    Expand Collapse

    Joined:
    Nov 29, 2014
    Messages:
    71
    That makes sense, thanks! I look forward to seeing (or should that be hearing) it implemented

    (The depth of my nerdism knows almost no bounds :p)
     
    • Like Like x 1
  19. Elving

    Elving
    Expand Collapse

    Joined:
    Aug 4, 2013
    Messages:
    333
    Same issue here. Have any idea if it´s a conflicting mod? I tried to remove all the D-series mods i could find, due to the update.
     
  20. fivedollarlamp

    fivedollarlamp
    Expand Collapse

    Joined:
    Sep 18, 2016
    Messages:
    3,144
    A healthy dose of self-promotion! Not sure if everyone's seen this, as it did get kind of buried. :oops:
     
Thread Status:
Not open for further replies.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice