Logitech G920 brake and gas pedal issue

Hi so my Logitech G920's brake pedal auto applies the brakes until I tap it or I hit the gas pedal.When I let off the gas the brakes auto apply again. My gas pedal keeps Auto applying the throttle even when I press It. I tried inverting it And it would make it so I had to fully press it to rev the engine. I tried everything without inverting it

 

1. You need to invert it cause the pedals on the G920 are inverted
2. Check the graph the shows when it responds and how much

 

My gas is fine now after I did what you said but My brake pedal stil auto applies the brakes

 

now my gas pedal does it again

 

Just use the setting I enclosed here as I know that it works fine, as I use them myself so thoise should work otherwise there may be something wrong with your wheel, the file in the zip is meant to be in the inputmaps folder in your Beamng.drive folder in your documents folder.

 

do i put it in all the cars or no
--- Post updated ---
Works Great!
--- Post updated ---
what do I need for throttle linearity what settings do you use

 

Weird because I never had this issue with my g920. Pulled it out of the box and after installing Logitech gaming software it worked perfect.

 

Just had to calibrate it!, Works Great!

 

Now acting up:[
--- Post updated ---

--- Post updated ---
whats the settings you use can you screenshot it pls
--- Post updated ---
so its my brakes are set to the down key

 

I'm using a G29 (PS4 variant), so hopefully the same thing will apply to yours






Also, do you have the Logitech Gaming Software installed?

 

Yes I have the software
--- Post updated ---
Thx!

 

I seriously dont get how you are having problems i literally plugged it in and assigned keys and i was off.

 

possibly dirty connections? because my g29 had the same problems of where it was applying throttle or brakes for no reason but when i sprayed electrical contact cleaner into where the connections are it cleaned it and now works fine.

 

Ok I will try that,Thx!
--- Post updated ---
Do you use joytokey?

 

Quoi?

Use the Logitech software as the firmware, and set up the wheel in beam. Don’t use any other external programs, as that is almost definitely the source of your issues.

 

Ok I use Logitech software I will now set it up in beam
--- Post updated ---
I will try later today when I get on my pc

 

Does the G920 have a switch on top of the "face" like the G29? If yes, then switch it to the right & that'll hopefully solve the issue

 

Lemme check
--- Post updated ---
No there is not.

 

Have you set your controls to the same as mine, as I showed in my previous post? In your initial post you said they are assigned to buttons instead of axis/sliders, so that is probably giving you the issue(s).

 

I’m going to do it tomorrow