Beta Covet AWD v0.7

FINALLY!!!

I've finally figured it out (I hope...........)

alr, so here's the changelog:

• Driveshafts no longer are out of place, AND SHOULD EVEN ROTATE AT THE CORRECT RPM!
• The issue from last update with the rear Driveshafts is now fixed, should be better than ever before!
• With the MR Layout, the Node of the Front Differential wasn't properly attached, this is now fixed, too!

well, would be too great if everything worked perfectly:

• MR Layout: Driveshaft rotates even if Front shaft isn't connected in the 4WD config
• As before, the Exhaust Heat Shield clips the Driveshaft*

* It's part of the vanilla body, so to do it properly I'd have to duplicate the body and thus make compatibility with other mods wayy worse. Might look into a "hack" to make it invisible though...

apart from that, the only thing missing is proper models for the MR Layout, but I still don't really know where the driveshaft should attach...
to the front on the Engine there are all the pulleys, and it's difficult to find a way around the engine to attach it there


AS ALWAYS:
Feedback is much appreciated!
Any Ideas? Answer the Discussion Tab or DM me!